Mains, PSUs and other goodies.

[JAZZCNC]

As to the first question about the current for the spur, no idea. I am not aware of any seperate fuse for this so I guess it's just a matter of checking the fuse for the ring downstairs.

Well in this case like I say you need to find out for sure because in this case the whole house is pulling off it and you could be stuffed unless you turn off everything else in house.!!

As for other comments about lights dimming on startup, is that a feature of a particular piece of equipment and can it be avoided?

This would indicate a really high initial draw so could be large transformer or dodgy motor pulling high Amps.? Could be many reasons.!
My lights don't dim and I run high power transformers and large motors with high power draw on startup like my big compressor.! There's many times I'm running CNC machine while I'm using Lathe with mechanical saw cutting in background and compressor kicking in & out blowing chips form machine, sometimes I even have extractor going at same time.

[Rogue]

Well in this case like I say you need to find out for sure because in this case the whole house is pulling off it and you could be stuffed unless you turn off everything else in house.!!

You're a little bundle of joy, sometimes, did you know that? Still, these are things that never occured to me that I'll need to worry about and address before, not after.

I'm stubbornly hoping this will all work out because I've not got another space I can use at the moment.

[JAZZCNC]

You're a little bundle of joy, sometimes, did you know that?

Ye I know it's my special gift but I'm going away tomorrow so you'll be ok for a few days untill I find the password for the wifi where I'm staying. . Lol

[WandrinAndy]

There's many times I'm running CNC machine while I'm using Lathe with mechanical saw cutting in background and compressor kicking in & out blowing chips form machine, sometimes I even have extractor going at same time.

And some womenfolk reckon we don't know how to multitask... tut tut