M542 wiring

[JAZZCNC]

ok try here ya go.

XN = negative so take a wire to pul - dir - En -

XD = direction so take to dir +

XS = step so take pul +

EN = enable so take En + ( This can be left unconnected and you do connect then the software enable pins need to be set up correctly else the drives wont turn on. Most leave unconnected)

Now this is very important don't jump the power wires between drives.? By that I mean not take a positive wire from PSU to first drive then jump from that to next and so on. Always fetch the wires direct to each drive from either the PSU or a bus bar type arrangement.

See pic.