I've been having far too much fun making a CNC router over the past few days to post here...

Quote Originally Posted by m_c View Post
Also I'm hoping to figure out some way to tweak the drilling operation, as pecking at 3mm intervals to stop the drill clogging in a 32mm deep hole is time consuming. Might swap that to manual code, as I reckon the first 15-20mm can be done without pecking but with just short pauses to break the strands, before going to full retraction pecking to prevent clogging...
I've done that before now in aluminium and nylon when I've had a lot of holes to drill. Find and replace works well, especially if you open it in notepad++