-
08-09-2012 #1
After reading Hilton Steve's post on his tool hight probe and how useful it was i thought id give it a go.
As i am a tad paranoid about driving my tool straight through the probe I also thought I would add a couple of E-Stop switches in parallel under the spring loaded contact
looks posh :)
simple :)
should have grabbed a sharper tool :(
the switches run straight back to my bob E-stop (iv not wired it up yet, ill feel much better when I do)... the washer makes contact to the brass contact through the spring
this could be made much lower profile as its a bit tall... i may have to have another go at this but for now ill see how we get on :)
-
08-09-2012 #2
Simple and clever that mate good idea.. .
On a side note and to reassure you I've used tool height and touch plate for years and never ounce failed or pushed tool thru plate or bed.
-
08-09-2012 #3
-
08-09-2012 #4
-
08-09-2012 #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Is there a specific setting for using a diamond drag tool for engraving?
By petesos in forum Tool & Tooling TechnologyReplies: 4Last Post: 14-03-2014, 12:22 AM -
Setting my table up...
By Davek0974 in forum Plasma Table MachinesReplies: 23Last Post: 10-03-2014, 08:24 PM -
Tool Height Setting Probe - Mach3 - solution
By HiltonSteve in forum Tool & Tooling TechnologyReplies: 18Last Post: 12-11-2013, 06:23 PM -
setting up a business
By dstivens in forum Opportunities Available & SoughtReplies: 5Last Post: 16-05-2013, 10:28 PM -
setting the origin
By Fivetide in forum Computer SoftwareReplies: 9Last Post: 04-02-2013, 12:18 AM
Bookmarks