So, I fixed the screw in the center line under the bed.

Then I fixed one end of each rail.

I then fixed a temp gantry to tie the 3 together, and ran the screw to the other end of the bed.

Then fixed the far en of the rails.

Then ran the gantry back a couple of inches at a time and fixed the rails as I went.

Quick phone vid of the X moving... remember , this is upside down at the mo.


CLICK IMAGE TO VIEW



I got it upto about 100IPM before it stalled, but I'm still running the drivers at minimum amps whilst testing. It's running at about 70IPM in the vid

Rich[/QUOTE]