.............................

So, not much done today to show.

I got the Y rails more or less aligned (good enough for now)

Simple setup with a set square and clamp, 1st I got the height from the bed equal along the length of each rail, and both rails equal to each other.

Then I checked the distance from the outer edge rail to rial along the length.











then I got to making some skate bearing trucks.

the rails are 31" long, my travel will be about 25" long, so I cut some angle iron to 7" and drilled the holes 1/2" in for the bolts for the skate bearings. spaced with nuts, and cut to length after with the angle grinder.





next to figure the best way to atatch the trucks to the Z carriage ???

I'll be asking that in another thread :)