help needed going to the next level

[luke11cnc]

Hello Jonathan
A really big thank you for helping me out with my drawing I've just cut a test piece in some 18mm MDF and I must say I'm really quite impressed with the result achieved I've not look at my software yet to reproduce the drawing yet but I'm hoping to do this next week.

I hope you had a good weekend with your project and nearing a finish line

Again thank you

may I come over some time for a small tutorial on my software ??

James

[Jonathan]

You're welcome...did you take any pictures?

I can give you a tutorial on the software if you want, when I've finished the project. However I strongly advise doing the tutorials that came with it first as I'm sure you'll get the hang of it easily from those...