My baby 15" x 15" machine

[wilfy]

believe me if i started this machine right now my mrs would lynch me.

i've got a bubble tube to finish which i am waiting on a pump to arrive from germany to finish off. i've also got to re-build the cabinet for the front room, now both of these HAVE to be done before i do anything else.

i also want to get my homebrew on the go which needs a circuit building for temperature control, which i have yet to even design, plus it then needs an enclosure. i would like to do this before i start work on the machine.

so as it stands i think i'm happy with my design but i need to clear some stuff out of the garage before i start it, gonna have a good push this weekend to get at least one thing done.

i should have got some of it done over christmas but being ill and one of my lads being ill didnt help and more importantly i had no money left over to buy stuff with

[Lee Roberts]

Wilfy, give Ainscough a try for box section they are down on Warrington Road. In fact if you give me a list of what you want i can call in tomoz morning for you as i walk past everyday on the school run.

.Me

[wilfy]

hey u bumped my thread lol... erm re: the steel i'm just holding back a bit at the moment, i'm going back to work full time in a few weeks so i'm hoping to get some pennies in the bank to pay for it.. the new van kinda ruined any chance of starting the cnc just now.

and with regards to ainscough, i thought they only did reclaimed stuff??

[Lee Roberts]

Not sure mate there website says they do box section, they list it as "Std, Clean or s/rusty" so was going to give them a try for myself at some point.

.Me