Thank you. Yes that makes perfect sense however at this very early stage and still by way of "introduction" ;) I should explain how I operate for example with motorcycles.

I like to buy "project bikes" which usually turn up in a variety of plastic buckets. I buy them super cheap and, if it's a buy to sell, I'll pick a target value and perform a rebuild/refurb commensurate with the equity. The more they are "worth" the more time and effort I can spend on them. I think you can see where I am going with this - I have "no idea" of the inherent value of these machines.

As a newbie to this forum, I don't want to be so boring as to bang on about values but the Denford is less interesting to me since it can't do steel. So really I just want to make it work and let it go.

So at the risk of being booted out of the "hello" section: what might I expect to sell an unmodded Denford micromill for and how much is my unmodded VMC190 "worth"?

Screwdriver.