Boxford VMC 190 (and a Denford micromill)

[irving2008]

Well £457 for the Denford... though I think thats on the low side, there were only 5 bidders. With a proper MACH3 conversion and modern drivers you could add maybe £200-£300 to that (I'm guessing) but whether it would make sense to do so is another question...

[Screwdriver]

Well £457 for the Denford... though I think thats on the low side, there were only 5 bidders. With a proper MACH3 conversion and modern drivers you could add maybe £200-£300 to that (I'm guessing) but whether it would make sense to do so is another question...

I don't know if that's cheap, I'd let mine go for that but in the meantime I'll see if I can get it going as it stands.

Guess it's time to take this into an appropriate section. See you in another thread ;D

Screwd.