Thread: Chip load chart
-
17-09-2012 #1
This a is a small chart to help with those of us that are doing lighter work. Always wondering what chip load to use so this may help.
MATERIAL CHIP LOAD INCHES METRIC
Minimum Average Minimum Average Solid Wood - Dense 0.006 0.015 0.1524 0.381 Solid Wood - Soft 0.008 0.02 0.2032 0.508 Particle Board 0.01 0.025 0.254 0.635 MDF 0.008 0.015 0.2032 0.381 Rigid Plastic 0.01 0.02 0.254 0.508 Flexible Plastic 0.015 0.025 0.381 0.635 Aluminum 0.002 0.009 0.0508 0.2286
BruceThe more I know, I know, I know the less. (John Owen)
-
The Following User Says Thank You to motoxy For This Useful Post:
-
17-09-2012 #2
This one is also useful: http://www.vortextool.com/images/chipLoadChart.pdf And gives the formula for using chip loads... at least as a starter for 10...
Last edited by irving2008; 17-09-2012 at 10:38 PM.
-
The Following User Says Thank You to irving2008 For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Profiled rails - Installation guidelines and manufacturer comparison chart
By mocha in forum Rails, Guideways & BearingsReplies: 5Last Post: 20-02-2014, 12:15 AM -
How to pre load screws
By graham4877 in forum Lead Screws, Nuts & SupportsReplies: 6Last Post: 14-08-2012, 11:07 AM -
PLC/Programmable chip suggestions
By m_c in forum General ElectronicsReplies: 9Last Post: 02-04-2011, 04:40 PM
Bookmarks