Due to a change in plan i've settled on a 1200mm for both X and Y. Ill be using 2 lengths of 60mm box section on a back plate with sbr25 rails to form the Y axis. Y is mounted on the X bearings near enough at the mid-point of the Y bearings. I've not drawn them in yet but ill put some diagonal pieces in to support the Y uprights against the X bearing plates.
Would taking the Y uprights below X bearings and box section and linking up with the opposite side of the X bearing plates offer significant more support to the X bearings?
Y bearings appear to be a little out of position. Everytime i move 1 bearing, they all move! I must have grouped them somehow. Going on the bearing blocks are 65mm i have a 20mm space between the 2 which make 150mm from one end to the other on each Y rail. Is this spacing sufficient?
Is it best to drive Y on the main Z back plate or can i use the shorter Z back plate? I'd like to protect the Y screw from any debris.


Attachment 7198
Cheers