Threaded View
-
29-09-2012 #3
Last Activity: 27-04-2020
Fivetide; JAZZCNC is dead right here. It matters not a jot what the battery capacity is; it's all about being of the appropriate voltage and of sufficient capacity. Even if you could get and use a battery with 1000000 Ah capacity it'll be fine, so long as V is OK. Mind you the battery would be huge but last for ages!
Just remember I=V/R Ohm's law.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
What voltage for stepper drive?
By Davek0974 in forum Plasma Table MachinesReplies: 1Last Post: 22-01-2014, 10:49 PM -
parralell port voltage.
By crossleymarko in forum Computer HardwareReplies: 71Last Post: 15-04-2012, 09:55 PM -
voltage on motor wires
By phill05 in forum General ElectronicsReplies: 9Last Post: 11-02-2012, 03:43 PM -
Alternator low voltage
By M250cnc in forum General ElectronicsReplies: 12Last Post: 24-02-2011, 11:23 AM -
Boxford VMC 260 steppers voltage?
By evildrome in forum Boxford Vertical MillsReplies: 3Last Post: 20-10-2010, 03:03 PM
Bookmarks