operation cnc

[JAZZCNC]

I hope not too disappoint!

So just about to place order for the breakout board on cnc4you, er this one

so, do I buy this? Breakout board CNC Stepper Motor 5 Axis Spindle Relay HG07

or this ZP5A-INT

forget about the differences in price.... im more concerened about the stated input voltage of the first board... (7 to 55v) as opposed to the 5v USB power input the second board has

What are other people using... I know Jonathon has suggested a board.. but its in the states... and im inpatient.

Don't cut corners on the BOB for the sake of getting the machine running has you'll spend more time chasing problems than you will cutting.!!

Personally I think BOB's are Bastards who deserve to be hung.!!. . But that's down to back stabbing mate and cheating bitch Ex-wife. . LOl . . . But seriously the BOB is the worst culprit of causing problems and dropped steps etc than any other component. Cheap BOB's are just not worth the hassle.

Both those are just OK and nothing to get excited about the (7to55V) is handy because it gives you more options to power, I don't like 5Vusb powered stuff has the USB isn't reliable enough so in any case it would get an external 5V supply.

If you want the Cream of BOB's look here but you'll pay for it.!! PMDX.COM - Products for CNC and motion control applications
The 122 is a good board and all PMDX stuff is high quality and they are very helpful with good warranty. PMDX.COM - Products for CNC and motion control applications

If was me then I'd buy the 126 for many reasons but like I say not cheap but quality isn't and you get what you pay for.!!
Not be impatient it will just cost you money and frustrating hair pulling.!!