How to connect 2.2KW Inverter VFD?

[Tenson]

Good eyes Jonathan, I hadn't noticed it came off!

I had set PD141 to 240V since I thought that was meant to be the over-voltage protection for the mains. I'm better to keep it at 220V, then?

I'll have to play with the VFD a bit more, the manual was hard to decipher.

Thanks again, I'll maybe post some videos again when I do more cutting.

[Jonathan]

I had set PD141 to 240V since I thought that was meant to be the over-voltage protection for the mains. I'm better to keep it at 220V, then?

It says in the manual that PD141 is the 'Rated Motor Voltage' and to set it 'according to motor nameplate' and my 2.2kW spindle has 220V written on it so that's what I went with. It's not going to make a great deal of difference to be honest.