Threaded View
-
25-10-2012 #2
Last Activity: 19-04-2024
Hi
Just had a look at the manual on page 23 it states that there is a RESET which will reset all parameters to factory defaults.
At least you can start again.
Hope I have not stated the obvious
Andy
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Hair growth device. DIY version
By gavztheouch in forum Electronic Project BuildingReplies: 16Last Post: 30-03-2014, 08:55 PM -
Ridges in 3D profiles = hair loss and lots sandpaper
By Shinobiwan in forum Machine DiscussionReplies: 9Last Post: 11-04-2013, 07:45 PM -
RFQ: Shot blasting or other paint removal
By craigrobbo in forum Projects, Jobs & RequestsReplies: 14Last Post: 01-02-2013, 12:21 AM -
Air cooling/SWARF removal
By m.marino in forum General DiscussionReplies: 14Last Post: 01-07-2012, 12:39 PM -
Heelp! Dual axis steppers.. Losing steps.. Pulling hair out..!
By fasteddy in forum Motor Drivers & ControllersReplies: 9Last Post: 14-05-2010, 02:32 PM
Bookmarks