. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 01-11-2012 #1
    Minium's Avatar
    Lives in Ely, United Kingdom.
    Minium
    Last Activity: 15-11-2012 Has been a member for 9-10 years. Has a total post count of 4.
    Hi Martin,

    it's actually 3mm rigid PVC which I machined on the CNC so that each cutout was a snug ( <1mm clearance) fit against the boxes. That sits on 1 mm holey rubber mat.

    Hi Peter,

    thanks, I thought you meant a piston based pump but best to check. I just need to find one which isn't going to break the bank.
    Last edited by Minium; 01-11-2012 at 09:30 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. I want a vacuum table!
    By Tenson in forum Machine Discussion
    Replies: 44
    Last Post: 08-01-2014, 07:40 PM
  2. vacuum table using compressed air
    By plasticman in forum Milling Machines, Builds & Conversions
    Replies: 6
    Last Post: 25-12-2012, 05:42 PM
  3. Custom Vacuum Table 'Hold Down' System - piping/valve advice
    By FlightCaseCo in forum Machine Discussion
    Replies: 4
    Last Post: 16-01-2012, 06:56 PM
  4. Much advice needed for an 8' x 4' cnc router project / and vacuum table
    By FlightCaseCo in forum General Discussion
    Replies: 1
    Last Post: 01-01-2012, 12:34 AM
  5. DIY Vacuum Table
    By templecorran in forum Machine Discussion
    Replies: 18
    Last Post: 10-11-2010, 12:11 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules