Hi all

I've just discovered this site while browsing the CNCZone forum.
It seems much better to have a UK based forum!

I'm currently in the planning stage of a small, probably 4ft x 4ft plasma table.
This will be used at home to prototype ideas for my small home based business.

All of this dictates I will be working on a budget! However, the good thing is the products I intend to make have little need of "fine" tolerances.

I had thought I would starting tonight.. but a recent thread has caused me to question my plans - so I'm back to square 1.

I'll not clog up the intros section with my quandary, hopefully I'll see you in the plasma section soon!!!

Ta ta for now

Danny