Threaded View
-
04-12-2012 #10
FiveTide,
Trust me been down the learning curve the hard way myself. To the OP, seriously for the money you are talking about; not only could you build a better machine then the one you pointed too but would also have the practical engineering experience that will do you well out in the real world. There is a lot of crap coming out these days and what folks are saying in their ads should land them in court.
As far as getting banned, hope not, but I can point out with experience and engineering facts where these machines are crap and are lying their back sides off.
Michael
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Best all round mill/router? Vertical mill or gantry router?
By Richard in forum Machine DiscussionReplies: 2Last Post: 18-02-2014, 04:18 PM -
Spindle Motor Recommendation.
By cambesol in forum Marketplace DiscussionReplies: 0Last Post: 21-11-2013, 12:15 PM -
Router bit recommendation, spindle speed and feed rate?
By FlightCaseCo in forum Spindles & Drive MotorsReplies: 13Last Post: 03-04-2012, 12:53 PM
Bookmarks