Threaded View
-
05-12-2012 #1
Last Activity: 17-06-2020
Gents,
curious if anyone with more cutting / CNC knowledge can share some light on this. How hard would it be to get zero or minimal (below 0.05mm) runout on a part like this:
Material is stainless steel, the part will be supported in the highlighted sections, diameter is 20mm and 14mm on the bottom part.
Regards,
dsc.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Diy 4th axis rotary table using 100mm chuck with minimal backlash
By kingcreaky in forum Linear & Rotary MotionReplies: 3Last Post: 05-09-2013, 01:03 PM -
shaft - grinding part joint
By dsc in forum Linear & Rotary MotionReplies: 9Last Post: 21-11-2012, 09:31 AM -
Simple Solution- Drive 1" Ball Screw Shaft with NEMA-23-Size Stepper Motor Shaft
By LoveLearn in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 08-02-2012, 01:52 AM -
correcting mill spindle runout
By cocoa_cnc in forum Spindles & Drive MotorsReplies: 4Last Post: 18-01-2009, 06:43 PM -
Measuring Spindle Runout
By Lee Roberts in forum Spindles & Drive MotorsReplies: 0Last Post: 18-10-2008, 11:47 PM
Bookmarks