Quote Originally Posted by martin54 View Post
Ok so what exactly have you had done? Did you get the router rebuilt & if you did is it now running upto date drivers & motors? If that's the case then you can chuck your gerber software in the bucket as it won't work anymore. If the machine has been rebuilt then the old gerber control system will have gone which is probably why you are getting a "Router not connected message"
I replaced all the original electronics & now run the machine using mach3 for the control software.

If the router was working fine & you were happy with it then your best bet would have been to source a really old computer & just reinstalled all the programs you had on your old machine on that. Would probably have cost you next to nothing to pick up a computer that old.
I have no problem with the router it was the PC that crashed.
I installed the latest disk I have and the composer and other programs work. When I try to open Artpath I receive an error message stating " no router installed use GSP setup.
I go to GSP setup and follow the install. Yet, when i go to Artpath I get the same message. I reboot the computer to help.
No luck.