Quote Originally Posted by GEOFFREY View Post
Jazz, As has been stated the idea would be to keep it simple, very rigid and straight forward to build. I am aware that cutting ally would up the anti, but it also vastly increases the scope of the machine, and would be useful for a "future" Monster build.
Geoff your falling into the "Bridge too far" trap.!! . . . Theres cutting Ali and cutting it correctly and I'm not guessing when I say it can't be done complete and working with spindle for under 1K and keep the simple to build Ideal. If this is really a design requirement then I'm out has I don't have time to waste on what I know can't be done.

Vertical works just the same has horizontal regards work holding and part cutout.? All material needs clamping even when horizontal, esp the cut part. You wouldn't leave a cut part unfastened so it could be dragged back into the cutter so you'd clamp,stick,tab etc to hold in place which applies just same when vertical.
The space saving is considerable when the machine size rise's but even a small machine could be large space saving when hung off a spare wall thats just holding up a roof.

Look round your workshop and find a wall with enough space for slightly deeper than your typical Kitchen double top cupboard and thats your CNC 600x600 machine.
Now look again and find a space on the floor or bench for 1sq meter with space in front or at side to stand and load/operate machine and see the difference.? . . . . What was you saying about no space saving.!!

Oh and 90% the chips fall away so you can sell that great big Vac needed before and get a nice small one for the bit thats left.! Put a simple frame with doors on front and it's clean and quite with minimal impact on workshop.