View Poll Results: Mach3 vs LinuxCNC/EMC What do you use and why?
- Voters
- 28. You may not vote on this poll
Threaded View
-
30-12-2012 #8
Why can't I vote for two. the vote is for Mach or EMC and then they stick other in.
I want to vote Mach and other seeing as i run two commercial machines with Ahha on them.
I don't want to get involved in a dick slapping contest between the two but just point out that if everyone who starts out in this hobby has to use Linux / EMC then I'm afraid the number would be cut by as high as probably 75% or greater.
I'm not saying one is better than the other as it would be totally impossible to define but familiarity with an operating system has to play a major part of any decision.
I know the Linux guys will jump on this and say it's not so but they are all, for want of a better word,and no disrespect, geeks, who are very, very familiar with the Linux operating system and cannot understand why others are not.
Why not just be content in using what you are most comfortable with.John S -
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Ubuntu 10.04 / Linuxcnc / heekscad & heekscnc -installation (steps of what I did)
By diy-john in forum CAD & CAM SoftwareReplies: 5Last Post: 19-06-2013, 07:35 AM -
LinuxCNC and Zapp Automation 3 axis kit - how to configure?
By gr8fun in forum LinuxCNC (EMC)Replies: 12Last Post: 10-04-2013, 09:11 AM -
How many LinuxCNC/EMC users do we have?
By birchy in forum LinuxCNC (EMC)Replies: 16Last Post: 30-12-2012, 08:08 PM -
Setting up LinuxCNC (Linux newbe)
By Mad Professor in forum LinuxCNC (EMC)Replies: 1Last Post: 04-03-2012, 09:22 PM
Bookmarks