Wiring up the Alarm output on Leadshine AM882

[JAZZCNC]

Given that they're NC when not activated, if you want to connect them through a single pin, then you'll need some way to invert the signal.

Missed this but it's easy fixed just set the Home input to Active low and it will see the signal when it goes low IE: The switch opens.

[m_c]

Missed this but it's easy fixed just set the Home input to Active low and it will see the signal when it goes low IE: The switch opens.

Still wouldn't work for homing ;-)
Wiring three to the same pin, unless you can make sure 2 are triggered (i.e switched open circuit) while you home the third one, it's not going to work.

[JAZZCNC]

Still wouldn't work for homing ;-)
Wiring three to the same pin, unless you can make sure 2 are triggered (i.e switched open circuit) while you home the third one, it's not going to work.

See what you mean and didn't give it a lot of thought plus I've Never used these type Switches so won't argue but I've just been looking thru PMDX126 manual and they use them wired in parallel on a single Pin so wouldn't be so sure.?