Thread: Spindle Stop?
Threaded View
-
07-01-2013 #1
Hi all.
Firstly, many thanks for all the help you have given me so far, especially with my LED + Limit Switch query.
While in my garage today, doing some wiring on my cabinet, I suddenly had a thought.
My Mill is on a standard 3 pin,13 amp plug, obviously it will be on a separate supply to the cabinet, my thought was this, what happens if the fuse blows to my Mill, will the Drivers keep on turning the Stepper motors, ie DISASTER. Please remember, I have no knowledge of Mach 3 yet, that's my next big learning curve,I assume that the electronics would detect an increase in Torque on the Stepper Motors and then shut down the electronics, trouble is i do not like assuming, because it makes an ASS OF U & ME, looking forward to your advice.
Regards
Ray
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
E-STOP Circuit - will this cause any problems?
By birchy in forum General ElectronicsReplies: 34Last Post: 18-12-2012, 04:35 AM -
I promise I will stop asking daft question soon. Ish.
By D.C. in forum Gantry/Router Machines & BuildingReplies: 27Last Post: 15-10-2012, 11:37 PM -
wiring e-stop button
By deannos in forum General ElectronicsReplies: 10Last Post: 14-01-2012, 11:03 AM -
End mill depth 'stop' rings
By HankMcSpank in forum Tool & Tooling TechnologyReplies: 10Last Post: 24-02-2010, 02:03 AM -
Wiring in power and E-stop on DIYCNC Board
By m.marino in forum General ElectronicsReplies: 2Last Post: 10-05-2009, 10:15 AM
Bookmarks