Spindle Stop?

[manofgresley]

Hi Guys

Thanks for your contribution so far, but i think there is still some misunderstanding, to answer a previous question, my Mill is powered from a Standard 13 amp 3 pin outlet. I have enclosed my BLOCK diagram of what is actually the condition of my system now, I have 3 different 3 pin 240 vac supplies, all with there own 10 amp fuse, if Mill blows fuse due to overload condition, cabinet and PC are still Powered.



Regards

Ray

[Ricardoco]

Hi Guys

Thanks for your contribution so far, but i think there is still some misunderstanding, to answer a previous question, my Mill is powered from a Standard 13 amp 3 pin outlet. I have enclosed my BLOCK diagram of what is actually the condition of my system now, I have 3 different 3 pin 240 vac supplies, all with there own 10 amp fuse, if Mill blows fuse due to overload condition, cabinet and PC are still Powered.



Regards

Ray

Ok then change it to this, Job Done.. if you can that is..



Rick

[manofgresley]

Hi Rick

That looks great many thanks, IYHO what would be the best way to divide the 240 supply, my thoughts are a 240 volt busbar in the cabinet, with a tap off to the Mill and a tap off to the rest of the cabinet.



Regards

Ray

[Ricardoco]

Hi Rick

That looks great many thanks, IYHO what would be the best way to divide the 240 supply, my thoughts are a 240 volt busbar in the cabinet, with a tap off to the Mill and a tap off to the rest of the cabinet.



Regards

Ray

As jazz has pointed out using a relay (with the correct rating)is really the best way, but if not then have their own fuses. But the first is preferred as there is a higher degree of control when using a relay. Rick