Thread: Ballscrew Size and Pitch
Threaded View
-
10-01-2013 #1
Advice required. If you were designing a steel framed router with rails 1800mm (X axis) and 1500mm (Y axis) and 620mm (Z axis) what size and pitch ballscrews would you use.
Because of the lengths of the X and Y axis they appear to be beyond the 1610 ballscrew because of whip, etc. I could use BK bearings at both ends but not sure what benefits that would provide.
I was thinking 1616, 2010 or 2020 for the X, maybe 1616 for the Y axis and 1605 for the Z axis although some of these seem expensive. Any suggestions?
Jim
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Milling machine yaw and pitch adjustment
By Golfer4588 in forum Milling Machines, Builds & ConversionsReplies: 1Last Post: 16-01-2012, 03:02 PM -
Fine pitch Bolts
By Normsthename in forum General DiscussionReplies: 1Last Post: 13-08-2010, 11:13 PM -
Stepper shaft size and pulley bore size problem
By psiron in forum Linear & Rotary MotionReplies: 13Last Post: 15-06-2010, 04:11 PM -
What pitch ballscrew would you recommend?
By AdCNC in forum Lead Screws, Nuts & SupportsReplies: 6Last Post: 23-02-2010, 02:08 AM -
Super X1 conversion - Lead Screw Pitch?
By bruce_miranda in forum Lead Screws, Nuts & SupportsReplies: 2Last Post: 19-09-2008, 01:29 PM
Bookmarks