What i am doing wrong with mach3?? trying to config machine.

[JAZZCNC]

Has it ever worked recently.? What's happening or not give more details please.

This looks a bit messed up regards wiring and bit of a hack job so will be a bit trial and error unless you know exactly where each pin goes. The sheet you show will help if it's correct.

Try these numbers in motor outputs for starters.
X Axis Step =9
X Axis Dir 12
Y Axis Step 10
Y axis Dir 13
Z axis Step 11
Z axis Dir 14

Also show use whats on the input signals Tab for E-stop.

Edit: The pins could also be this way round depending on the how the Sheet reads.

X Step =2
X dir = 5
Y Step = 3
Y Dir = 6
Z Step 4
Z dir = 7