. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 24-01-2013 #11
    Zadig's Avatar
    Lives in Lancaster, United Kingdom.
    Zadig
    Last Activity: 19-05-2022 Has been a member for 9-10 years. Has a total post count of 27.
    My Shizuoka has an old relay logic array to control the tool changer. I am in the process of changing this to an arduino - or I was until I came across CuBloc. It uses an Arduino platform and programs in Basic and Ladder. Again the software is free, but for PLC use they look great. I like C# and have no great knowledge of Basic but I do fancy getting an insight into Ladder.

    http://www.audon.co.uk/cubloc_cpu/CB210.html
    Last edited by Zadig; 24-01-2013 at 06:48 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help Make 1st Step - Wiring Up Drivers to Motor and Arduino
    By Treemonkey in forum General Electronics
    Replies: 10
    Last Post: 25-04-2013, 05:47 PM
  2. CNC Controller with Arduino and Gamepad
    By Christian Knuell in forum Electronic Project Building
    Replies: 2
    Last Post: 20-10-2012, 10:25 PM
  3. Imported L298 Arduino Modules
    By boldford in forum Motor Drivers & Controllers
    Replies: 4
    Last Post: 30-07-2012, 11:06 PM
  4. ​DIY arduino CNC 2 axis table
    By ruthharm84 in forum Electronic Project Building
    Replies: 5
    Last Post: 06-05-2012, 01:54 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules