. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 27-01-2013 #5
    cncnoob's Avatar
    Lives in Exeter, United Kingdom.
    cncnoob
    Last Activity: 25-02-2013 Has been a member for 9-10 years. Has a total post count of 9.
    That looks good!

    I am little confused however as Jonathan has put that I require 24v..

    So would I run the 24v through the micros and then step down to 5v through the Optos?

    Also I'm looking to build a board that will max out the inputs to the PP..
    I have found a lot of them have drivers also/bi dir, but I am looking to DIY an input system that will handle as many inputs as physically possible.

    I have found this PP as a secondary, before I go ahead and but it, is this suitable?

    http://www.kenable.co.uk/product_inf...oducts_id=1683

    (Am I right in saying I am looking for an ECP/EPP compatible card?)
    Last edited by cncnoob; 27-01-2013 at 05:21 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. EMC2 home/limit switches... only acting as limit?
    By vputz in forum LinuxCNC (EMC)
    Replies: 4
    Last Post: 15-10-2014, 09:51 AM
  2. Limit Switches
    By Leadhead in forum General Electronics
    Replies: 1
    Last Post: 16-10-2013, 10:41 AM
  3. Limit Switches with LED's
    By manofgresley in forum General Electronics
    Replies: 30
    Last Post: 02-01-2013, 03:08 PM
  4. Limit switches keep activating
    By davethefixer in forum General Discussion
    Replies: 2
    Last Post: 23-09-2012, 10:12 PM
  5. Limit Switches
    By Lee Roberts in forum General Electronics
    Replies: 13
    Last Post: 27-06-2008, 02:21 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules