1250 x 1250 cnc router (from scratch)

[JAZZCNC]

New pulleys required Dan don't waste time with bushes etc not worth the hassle and would take just has long to make as boring new pulleys.

My Lathe is down at the moment else I'd offer to bore some new pulleys for you but sure some other kind sole might offer there services.!!

Regards The Vaccum then you want it controlled by an output then use M7 or M8 to turn it on and M9 off. To do this is just the same as with the spindle.
Select an output # in Mach's Ports n pins and set to the Pin number your using for the relay, either one built into BOB or separate controlled thru an output pin (or both).
Then in Spindle setup in ports n pins uncheck the "disable flood mist relays" box then enter the output # number (not pin number but OUTPUT number used) for either M7 or M8 depending on which M code your going to use in the G-code for turning on the vacuum. You can set a delay for it to come on if you want in the box next to Output #.

Thats all there is too it.!!