Thread: Dc servo driver
Threaded View
-
30-01-2013 #1
Hi all,
I bought 3 dc servo drivers off eBay and cannot really find any information on the case to get any further detailed information :(
I have the matching motors for the drives which are wired into blocks which slot in so they are no problem.
This leaves 7 terminal screw blocks.. I've done a test using an old atx psu powering it up using 12v and the motors ran. The supply was connected to terminals 5 and 7 so I assume that 6 is for a ground. Terminals 1,2 and 3,4 are respectively shorted with bits of wire.
so can anyone help me figure out what 1,2 and 3,4 are and how I may control it?
I can add a picture tomorrow if that will help.
many thanks,
SamLast edited by Treemonkey; 30-01-2013 at 10:16 PM. Reason: Crap title!
Thread Information
Users Browsing this Thread
There are currently 9 users browsing this thread. (0 members and 9 guests)
Similar Threads
-
AC servo motor help !
By rnr107 in forum Stepper & Servo MotorsReplies: 35Last Post: 10-08-2015, 02:37 PM -
Closed loop Step Servo Drive Driver 2HSS86H + 4.5N.M Motor + Encoder
By george uk in forum Motor Drivers & ControllersReplies: 20Last Post: 23-06-2014, 08:38 PM -
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
400W servo - Leadshine ACS806 + ACM604V60 driver - PSU size?
By dsc in forum Stepper & Servo MotorsReplies: 10Last Post: 23-04-2013, 05:33 PM -
re servo encoder
By Scott in forum General ElectronicsReplies: 6Last Post: 24-06-2010, 08:30 AM
Bookmarks