. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-02-2013 #11
    marbles's Avatar
    Lives in glasgow, United Kingdom.
    marbles
    Last Activity: 15-08-2024 Has been a member for 9-10 years. Has a total post count of 174. Received thanks 8 times, giving thanks to others 92 times. Referred 1 members to the community.
    Correct!! It must be that one side of the vernier jaws is out as I have to reverse them to measure the inside and out. Thanks for all the advice, much appreciated.

    A bit of emery and on the bearings went. Worth asking the question thought as i'd not done this before and I didnt want to jam them on.

    I wonder now if the retaining nut with the grub screw at the top of the twin bearing unit is enough to hold that lot, would a second nut be useful and if so where can I get one in the UK?
    Last edited by marbles; 09-02-2013 at 07:53 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. taper roller bearings vs deep groove ball bearings
    By dsc in forum Linear & Rotary Motion
    Replies: 8
    Last Post: 10-03-2014, 08:06 AM
  2. dont you just hate it when...
    By mocha in forum General Discussion
    Replies: 6
    Last Post: 15-07-2012, 12:16 AM
  3. Boxford TLC 125 ballscrew bearings
    By lamestllama in forum Boxford Lathes
    Replies: 2
    Last Post: 25-03-2011, 05:57 PM
  4. Ballscrew Support Bearings - Angular or Self Align or ??
    By williamturner1 in forum Lead Screws, Nuts & Supports
    Replies: 8
    Last Post: 02-10-2010, 02:38 PM
  5. EXPERIENCE: Dont Use Modular CNC Technology!
    By leaveme in forum Trading Experience & Feedback
    Replies: 0
    Last Post: 14-09-2010, 05:44 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules