Thread: Speeds and feeds deep drilling
Threaded View
-
08-02-2013 #1
Tried asking this in another forum but got no reply.
I have just cncd my sx2 mill with 280 oz in (1.89Nm ) motors, xylotex controller and 1605 ball screw and nuts.
I'm drilling deep holes 27mm through aluminium with a new 5mm hss drill.
I'm using the following deep drill gcode G98G83X6.749Z-27.066Q0.531R3.0F10 spindle running at 2500Rpm.
It's taking over 35 minutes to drill 4 holes and I'm losing steps.
There's no counter balance or gas struts on the mill and I'm using WD40.
Question should I expect to get faster results without losing steps.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Feeds and speeds
By dudz in forum Tool & Tooling TechnologyReplies: 0Last Post: 26-08-2013, 11:42 AM -
Engineering Calculators - speeds, feeds, torque, etc.
By birchy in forum Machine DiscussionReplies: 0Last Post: 16-06-2013, 01:42 PM -
Advice needed on feeds and speeds!
By lateAtNight in forum Machine DiscussionReplies: 5Last Post: 14-11-2012, 12:47 PM -
Speeds and Feeds
By Web Goblin in forum Tool & Tooling TechnologyReplies: 0Last Post: 20-09-2012, 01:38 PM -
How deep can i cut MDF?
By MrWiz73 in forum Machine DiscussionReplies: 6Last Post: 24-08-2011, 10:38 PM
Bookmarks