Thread: Speeds and feeds deep drilling
Hybrid View
-
09-02-2013 #1
Until the iron saturates, torque is proportional to current, so yes it's likely to help. Keep an eye on the motor temperature though - no more than 80°C on the case is allowed. Do you have the model number of the motors so we can check what current they should be run on? Iff the motors, drivers and power supply are safe operating from 3.5A you might as well put them all on that current and get better feedrates or reliability.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Feeds and speeds
By dudz in forum Tool & Tooling TechnologyReplies: 0Last Post: 26-08-2013, 11:42 AM -
Engineering Calculators - speeds, feeds, torque, etc.
By birchy in forum Machine DiscussionReplies: 0Last Post: 16-06-2013, 01:42 PM -
Advice needed on feeds and speeds!
By lateAtNight in forum Machine DiscussionReplies: 5Last Post: 14-11-2012, 12:47 PM -
Speeds and Feeds
By Web Goblin in forum Tool & Tooling TechnologyReplies: 0Last Post: 20-09-2012, 01:38 PM -
How deep can i cut MDF?
By MrWiz73 in forum Machine DiscussionReplies: 6Last Post: 24-08-2011, 10:38 PM
Bookmarks