Hybrid View
-
26-02-2013 #1
Ok first does this happen just on Z axis or all Axis.?
If just Z axis that faults then swap outputs on BOB for one the other Axis outputs and see if it works. If still faults then it's some were else down the Z axis chain.?
Work methodical down the chain by swapping known good components, before that thou check wires because chances are you have motor phases wrong on drive and they are protecting them selfs.? Shouldn't be hard to find.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
are these a newwer version usb break out board the ones from austrailia - better?
By nobby in forum General ElectronicsReplies: 0Last Post: 13-02-2014, 07:09 PM -
Break board 3-axis optical isolation, simple!
By thjremy in forum Electronic Project BuildingReplies: 0Last Post: 06-04-2013, 04:42 PM -
Requirements on a break out board?
By Sodster68 in forum Motor Drivers & ControllersReplies: 3Last Post: 21-01-2013, 02:58 PM -
Stepper Driver / PSU / Breakout board Wiring ?
By manofgresley in forum General ElectronicsReplies: 2Last Post: 16-08-2012, 05:41 PM -
Motor controller next to break out board?
By m_c in forum General ElectronicsReplies: 2Last Post: 17-11-2010, 01:56 PM
Bookmarks