May you please have a look at my program ?

[Peter Griffin]

On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.

[hoezap]

On the die drawing the program is not quite correct. After the Cycle Definitions you must use Cycle call not Call label. Also the M6 command (Tool Change) should go after the Tool Define.

Ok I know about cycle call

About the M6 command (Tool Change) after the Tool Define, not all the heidenhain software require it

Thank you very much Peter Griffin