Where is that from? Looks like some sort of repo warehouse. Did they have any more?
The machine in the pic is from a rep site in america not the exact machine I bought.

If you have to ask this question I query whether you are the right person to be doing this move ?

Sorry if this sounds a bit harsh but 6 people don't throw one of these on their shoulders, there is a lot to take into account as regards how it's lifted to prevent distortion etc.
I don't indend on doing the move myself just making sure it gets done right, or as close to right as possible the machine is being sold as scrap so its a bit of a salvage job. I have a few options the best of which would be a hiab capable of lifting this, as most are rated at below 3. The other option is a flatbed trailer loaded with a forklift, the tines would need to be long enough to get the full way under the machine. If I use a forklift, I could lift it all the way outside of the building and onto the lorry in one go, otherwise I would need for toe jacks and machine skates or the forklift again to take it outside to the hiab.

The problem is my end as I only have two telehandlers rated at 3ton each. So I might need use both, one each side of the lorry,lift the machine and then move the lorry forward and lower the router. Cover the machine with a hap for the meantime and then rent a bigger forlift to lift into place.

For the lift I plan to centralise the weight as best as possible, lock all axis in place, spread the forklift tines as wide as possible and cross my fingers.