Threaded View
-
21-02-2013 #19
Sorry Jazz i was reading the thread all serious how you was helping out then it was like someone popped your balloon. Can i buy you a new one to say sorry????
I will admit i am feeling guilty but it was funny......... I went into factors a couple of months ago to get some bits for my car. I asked for some parts for a nissan praire. The guy disappears for about ten minutes and returns with a shed load of bits. He says to me " i knew i had a bunch of stuff hanging around, you can have this lot for nothing as i will never sell it". I had to disappoint him and say i drive a nissan largo. He looked all puzzled to which i replied that if i had said they were for a largo he would not have known what the hell i was talking about. He was quite pissed that he wasted all that time digging the stuff out. I id get the bits i needed though.If the nagging gets really bad......Get a bigger shed:naughty:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Improve Kress TIR or get an upgrade?
By Hauk in forum Kress Milling MotorsReplies: 3Last Post: 23-02-2014, 06:18 PM -
Feeds and speeds
By dudz in forum Tool & Tooling TechnologyReplies: 0Last Post: 26-08-2013, 11:42 AM -
trying to improve my board game
By cubikoman in forum General DiscussionReplies: 28Last Post: 12-05-2012, 06:57 AM -
NEW MEMBER: cubikoman needs to improve quality of his boardgame
By cubikoman in forum New Member IntroductionsReplies: 2Last Post: 16-02-2011, 12:17 PM -
Dremel into spindal board
By D-man in forum General ElectronicsReplies: 0Last Post: 08-10-2009, 08:42 AM
Bookmarks