Thread: Z safe in g code question
-
20-02-2013 #1
Hi guys , quick one in the code below is the Z safe set ? Its NCStudio so it might look a bit strange ..
N70G0X0.000Y0.000S15000M3
N80G0X108.535Y0.000Z16.699
N90G1X0.000Z-2.435F3000.0
N100G1X200.000F2400.0
N110Y2.381
The problem is its rising 10 mm and I only have 9 - 8 mm before the stop kicks in on the Z axis, I want to set it to say 4 mm to stop this happening.Last edited by Fivetide; 20-02-2013 at 06:31 PM.
Fiction is far more plausible when wrapped around a thread of truth
Nothing great was ever achieved without enthusiasm.
Ralph Waldo Emerson
-
20-02-2013 #2
Z is set to 16.699 in there
-
20-02-2013 #3
Thanks AdCNC so if I set it to say 000Z05.00 would that work or would it be 000Z5.00 ?
Fiction is far more plausible when wrapped around a thread of truth
Nothing great was ever achieved without enthusiasm.
Ralph Waldo Emerson
-
20-02-2013 #4
Ignore what is in front of the Z thats part of the Y coordinates. And yeah, you don't need put a 0 before the 5 just put 5 or what ever you like. :-)
-
20-02-2013 #5
Btw you can ignore the N80,N90,N100 etc that is at the start of each line, thats just line numbering and its set on yours in increments of 10 this does not have any effect on the g code
Last edited by AdCNC; 21-02-2013 at 12:31 AM.
-
20-02-2013 #6
Thanks Ad , just one other question if you have time, can I splice the finishing code under the roughing code as I'm attempting to use the same tool for both to try and speed things up ? I have done some test and the ball nose dose exactly the same job as the end mill bit on the wood i'm using.
Fiction is far more plausible when wrapped around a thread of truth
Nothing great was ever achieved without enthusiasm.
Ralph Waldo Emerson
-
20-02-2013 #7
Yeh sure buddy
-
The Following User Says Thank You to AdCNC For This Useful Post:
-
20-02-2013 #8
Fiction is far more plausible when wrapped around a thread of truth
Nothing great was ever achieved without enthusiasm.
Ralph Waldo Emerson
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Need to slow down a signal due to Safe Torque Off alarm
By corkcnc in forum General ElectronicsReplies: 0Last Post: 04-06-2014, 11:35 PM -
Safe Z Speed
By dudz in forum Artsoft Mach (3 & 4)Replies: 23Last Post: 24-05-2014, 04:08 PM -
Cambium Code Web Tools – Parametric G-code Generation
By CambiumMachines in forum Manufacturer NewsReplies: 0Last Post: 09-01-2013, 04:56 AM -
Safe Z Arghhhhhhhh!! Whats going on!
By AdCNC in forum Machine DiscussionReplies: 9Last Post: 18-08-2009, 05:15 PM -
G Code help
By moose007 in forum Programmers CornerReplies: 4Last Post: 22-05-2009, 11:39 AM
Bookmarks