Small wooden parts

[Philly]

The seam can be practically invisible if done correctly. You could also slush cast it(makes a hollow piece but saves a lot of resin). Any reason you wont be painting it?

[Tabclear]

I am not sure hollow will work, it needs to be quite solid, plus has 3 quite deep holes in it.

The part forms part of some jewellery, the original reason for wanting it to be made of wood was longevity and resilience. It going to be knocked, rubbed, twisted, scrapped - I don't want paint to be scrapping off, fading chipping etc... It really needs to last a lifetime of being worn by someone.

[GEOFFREY]

I am not sure hollow will work, it needs to be quite solid, plus has 3 quite deep holes in it.

The part forms part of some jewellery, the original reason for wanting it to be made of wood was longevity and resilience. It going to be knocked, rubbed, twisted, scrapped - I don't want paint to be scrapping off, fading chipping etc... It really needs to last a lifetime of being worn by someone.

Then I would guess the best answer is to stick with your original idea.There are few people that could do it, but it will be expensive - look at Jazz's comments.G.

[Tabclear]

Then I would guess the best answer is to stick with your original idea.There are few people that could do it, but it will be expensive - look at Jazz's comments.G.

Yeah I think you are right. I guess the initial cost to get things set up to make the first one could be quite high, but maybe the cost would go down for each subsequent one after that? I'm just guessing..

Could anyone here give me a rough estimate?... Would be great if someone was in the Hertfordshire area so I could pop along and maybe help out - moral support mostly I would guess :-)

Failing the above, can someone recommend a desktop CNC machine that I might purchase to do this myself?

Cheers
Tab