The 2.2Kw Chinese Spindles - Info, Setup and Advice + More

[ericks]

I have fitted well into the 100's of these Chinese spindles and I've had ZERO fail due to the connectors not being able to handle the load.
In my experience, the only weak link (other than being lower quality to brand names) with these spindles/VFD's is a lack of cable restraint. Both at the Spindle and the VFD you need to restrain the cable so the don't move around. I've only ever had 3 fails with connector faults and all of them where because the cable restraint I'd fitted had been left unconnected after the customer had moved or adjusted spindle etc and not fastened cables back up.

It's common sense really. . . which isn't so common these days.!

From your reply i would say you are unaware of proper wiring and component selection requirements :)

[cropwell]

From your reply i would say you are unaware of proper wiring and component selection requirements :)

I seriously doubt that Jazz is unaware of anything to do with CNC.

[JAZZCNC]

From your reply i would say you are unaware of proper wiring and component selection requirements :)

Well, you'd be wrong but your reply tells me you have little to no experience of these Spindles.! . . . However, Lets put this to the test because I know lots of folks on this Forum have these spindles and see how many on this forum have had issues with loads and pins/connector.?

So Hands up who as one of these spindles and as had troubles with the pins NOT handling the loads.! By this I mean Pins burning out or catching fire due to excessive load and not spindles blowing up because pins touched due to poor soldering/insulation or bad cable management.!