The 2.2Kw Chinese Spindles - Info, Setup and Advice + More

[MikeyC38]

Hi Jazz
As always the font of wisdom for us newbies. I forgot about these ports on the VFD. I was thinking about these to enhance my safety system by getting the relay ( based on your wonderful simple design emergency stop setup) to signal the VFD to stop when the safety button switch is operated.

Cheers
Mike

[JAZZCNC]

Hi Jazz
As always the font of wisdom for us newbies. I forgot about these ports on the VFD. I was thinking about these to enhance my safety system by getting the relay ( based on your wonderful simple design emergency stop setup) to signal the VFD to stop when the safety button switch is operated.

Cheers
Mike

Yep, that would work and there are various ways it can be done, to be honest. The controller or Bob your using will also play some part in which approach to use.

If I'm using a controller that doesn't have relays built into it then I control a relay for on/off using an Output. I then use this relay to turn the water pump on as well.