Quote Originally Posted by ericks View Post
From your reply i would say you are unaware of proper wiring and component selection requirements :)
Well, you'd be wrong but your reply tells me you have little to no experience of these Spindles.! . . . However, Lets put this to the test because I know lots of folks on this Forum have these spindles and see how many on this forum have had issues with loads and pins/connector.?

So Hands up who as one of these spindles and as had troubles with the pins NOT handling the loads.! By this I mean Pins burning out or catching fire due to excessive load and not spindles blowing up because pins touched due to poor soldering/insulation or bad cable management.!