The 2.2Kw Chinese Spindles - Info, Setup and Advice + More

[Shinobiwan]

Here's some useful setup information for Haunyang VFD that I've collected and collated whilst on my internet travels.

NOTE: Always check these settings are applicable to your Haunyang VFD as there have been some design variances over the years.

VFD Manual:


General VFD setup:
Here's the correct settings for the Huanyang VFD that always seems to come with these kits.

PD013 - 8 MASTER RESET <<< DO THIS FIRST
PD005 - 400
PD004 - 400
PD003 - 400
PD006 - 2.5
PD007 - 1.20
PD008 - 220
PD009 - 15
PD011 - 120
PD014 - 1
PD015 - 1
PD072 - 400.00
PD143 - 2
PD142 - 7
PD144 - 3000, factory setting is 1440 ->3000 gives correct RPM of 24000 at 400hz

Control Settings:
For spindle Start/Stop using Mach controlled relay connect DCM to FOR with the relay wired between the two. NOTE: Wiring DCM to REV will give reverse spindle rotation.

For variable speed control using a 10k ohm pot connect ACM and 10v to the pot with IV on the Wiper.

PD001 - 0 = Start from VFD Panel(Manual control), 1 = Control from inputs(use if Mach is start/stopping your spindle as explained above)
PD044 - 2
PD045 - 3

Spindle end wiring diagram:
(Pins are numerically marked on the inside of the plug, check by taking the 3 hex bolts out the spindle top cap. Whilst your in there take a ground from pin 4 to one of the 3 bolts inside that holds the bearing cap)


VFD end wiring diagram:
Live = R, Neutral = T, Earth = E.