Thread: Rotating Ball nut
Threaded View
-
08-03-2013 #20
Last Activity: 08-09-2018
You will have a problem pulling it straight. the only reliable method is to press it out. small amounts at a time, mark and check against a flat surface.
If the nagging gets really bad......Get a bigger shed:naughty:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Rotating Ballnut - design ideas
By Jonathan in forum Open Source Designs & PlansReplies: 215Last Post: 29-01-2024, 09:27 PM -
Rotating Ballnut Design MK3
By Jonathan in forum Linear & Rotary AssembliesReplies: 0Last Post: 15-12-2013, 01:35 PM -
advice on floating bearing - outer ting rotating
By dsc in forum Lead Screws, Nuts & SupportsReplies: 8Last Post: 18-11-2013, 02:23 PM -
Re-filling a ball nut
By Robin Hewitt in forum General DiscussionReplies: 2Last Post: 10-08-2011, 11:32 AM -
ISEL Ball nut
By cncezee in forum Lead Screws, Nuts & SupportsReplies: 9Last Post: 02-10-2010, 12:11 PM
Bookmarks