Thread: Delrin drive nut (lee)
-
05-04-2009 #21
-
07-04-2009 #22
Yes me :), ill send you a PM now !
.Me
-
10-10-2009 #23
Hi lee can you make 10x2 trap nuts similar to the nut blocks you made me before?
-
11-10-2009 #24
Lee if you get stuck for taps and dies mate just let me know, we use M3 right through to M20.
Just do your batch and send them back its up to you fella
-
11-10-2009 #25
-
12-10-2009 #26
10x2 trap.....humm no i think the only one i'v got is 1/2" 10x2 in ACME. I can send you some delrin and you could grab a tap from ebay ?
.Me
-
12-10-2009 #27
if you are looking for couplers http://www.fish4parts.co.uk/Mechanic...F+SWQ%29.1852/
-
13-10-2009 #28
-
14-10-2009 #29
Humm...
Of the three tap types, there is a tapered tap for the initial thread cutting, an intermediate type, this is used to progress the thread.
Finally, a "Bottoming" tap, this is used to obtain the full thread depth when cutting a thread that does not go the whole of the way trough the piece. (Your hole to be tapped has a bottom to it AKA (pocket).
So you would put a taper on it and then some slots/flutes:
:).Me
-
14-10-2009 #30
put a 4" length of trap rod in a drill chuck or lathe. Spin it up and apply a file to the last inch to taper it to the thread depth. Lock the chuck or hold rod in vice) and grind 3 'slots' at 120deg for 3" using a thin cutting disc (or file it if you feel up to it). lastly file the untapered end to a square.
Good enough for delrin. For a tigher finish lightly file the overall thread by about 0.05 - 0.1mm
I did it and it works... for nylon or acetal a few times... but wont do brass without hardening...
Thread Information
Users Browsing this Thread
There are currently 3 users browsing this thread. (0 members and 3 guests)
Similar Threads
-
Delrin Lead nuts.
By Kammo1 in forum Gantry/Router Machines & BuildingReplies: 14Last Post: 27-01-2016, 08:36 PM -
coloured delrin/acetal uk suppliers?
By dazza in forum Marketplace DiscussionReplies: 5Last Post: 26-05-2014, 12:35 PM -
Tapping Delrin for M10 threaded rod - doable?
By HankMcSpank in forum Machine DiscussionReplies: 7Last Post: 02-02-2013, 12:31 AM -
Delrin & Nylon S & F please
By craigrobbo in forum Machine DiscussionReplies: 2Last Post: 21-07-2012, 12:19 PM
Bookmarks