Delrin drive nut (lee)

[HankMcSpank]

Now I'm confused.

the post is entitled Delrin Drive nut (& it was always my interpretation that a drive nut is like the pic you've just posted above!), but in post 5 on this same thread (ie back on page ), has this photo...



in that photo they look like couplers? (so the thread morphed a little & confused me!)

(original post - [ame="http://www.mycncuk.com/forums/showpost.php?p=2745&postcount=5"]MYCNCUK - View Single Post - Delrin drive nut (lee)[/ame] )

Do you still sell the pictured couplers as mentioned in the photo in 'post 5' of this thread for £7 each? (specifically M8 threaded rod to stepper shaft of 6.35mm diameter)

I reckon there's a good business op for someone to knock these couplers out at a reasonable 'pack of three' cost! (as all the couplers I've seen to date would mean if I bought them, it would result in more cost than the rest of my whole CNC build!)