Geckodrive G540 re-wire/installation

[Phildunk]

Hi Jonathan,
Thank's for getting back to me. My name is Phil. I know less than nothing about electronics, but I know how to use three axis cnc. I bult a CNC by merging two old Dahlgren engravers. I think they should work ok. I have attatched some photo's of controll unit. The guy who built the controller told me that he had it up and running on his equipment.
After picking it up I lost my job so did nothing with it for a few months. When I came to wire the limit switches to the 9 pin D connectors I found there was a wire off. This is a limit switch wire. I put it back where I thought it came from. Since then I have no power to the Geckodrive.
I have looked over the wires and can't remember which one it was. I have also checked the fuse on the Gecko mother board and got continuity across it.

Thanks Phil
Home Phone No.