. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 16-04-2013 #7
    JayPunchbuggy's Avatar
    Lives in Basingstoke, United Kingdom.
    JayPunchbuggy
    Last Activity: 26-01-2014 Has been a member for 9-10 years. Has a total post count of 16. Received thanks 1 times, giving thanks to others 1 times.
    Hmmm... I used an RS-232 to RS-485 converter, not a USB one. Wonder it this could make a difference? Will think about it.

    Are you able to enter a target rate into Mach3 and then hit F5 and get the spindle to start and reach that rate?
    Last edited by JayPunchbuggy; 16-04-2013 at 10:52 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Similar Threads

  1. Mach3 Controlling Huanyang HY02D223B 2.2KW VFD
    By Mad Professor in forum Spindles & Drive Motors
    Replies: 34
    Last Post: 01-10-2016, 10:21 AM
  2. Mach3 ports and pin setup to match my control box
    By Sparky in forum Artsoft Mach (3 & 4)
    Replies: 17
    Last Post: 13-11-2014, 04:00 PM
  3. can mach3 burnout transistors on a CNC control board?
    By kevinb in forum Artsoft Mach (3 & 4)
    Replies: 12
    Last Post: 29-11-2010, 04:24 AM
  4. HID interface for remote control of Mach3
    By Smiler in forum Electronic Project Building
    Replies: 0
    Last Post: 10-05-2009, 12:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules